Bearing questions and Rails questions

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Bearing questions and Rails questions

This topic contains 5 replies, has 4 voices, and was last updated by  Jerky_san 1 month ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #106237

    Jerky_san
    Participant

    So I am going through the parts trying to build out a good quality mpcnc.

     

    First bearings

    How important are the bearings? I was discussing the build with my brother in law who offered me skf bearings 608-2rh for an incredibly good price. It will of course be more expensive than cheap Chinese bearings but he is offering me enough to finish the build. So if I were to buy them would I see better prints over cheap Chinese?

     

    Next the rails. I’ve read stainless steel is more Ridgid. I plane on doing a 2ft by 2ft build and I want to do aluminum milling. Is stainless steel going to make a drastic difference in the quality of the mill?

    Sorry for the questions.. I am experienced in 3d printing but new to milling/cnc

    #106284

    Jamie
    Participant

    If you buy the cheapest bearings you can find, they may well not be very smooth. I did, and I was unhappy with how they felt. I don’t know if it would have mattered in the finished machine but I bought better bearings anyway so I wouldn’t have to find out. Probably chinese not-quite-cheapest is fine, but if you have a line on quality bearings for decent price, I would go with that and save time.

    At 2′ x 2′ the rails wont matter much. Conduit should be fine.  At those dimensions the Z height is the most critical thing.

    1 user thanked author for this post.
    #106419

    Jerky_san
    Participant

    Thanks for the response. I’ll talk with him and get them then. Also guess I’ll do emt first and if I don’t like the result then I’ll do stainless

    #106422

    Erwin Vigilia
    Participant

    Also guess I’ll do emt first and if I don’t like the result then I’ll do stainless

    If you do switch to SS from EMT, you may need to print up a batch of new parts… something to keep in mind.

    #106449

    Barry
    Participant

    You will need to print all the parts if you change up to 1 inch stainless.

    1 user thanked author for this post.
    #106462

    Jerky_san
    Participant

    Hmm that’s a lot of work so guess I better settle on what I’m doing.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.