Auto square dual endStops on max position

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Auto square dual endStops on max position

This topic contains 1 reply, has 1 voice, and was last updated by  FX 3 weeks, 3 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #76312

    FX
    Participant

    I just installed the dual endstop firmware and I would like to home the MPCNC on the X and Y max position. What do I need to change in the config?

    Thanks

     

    #76321

    FX
    Participant

    I figured it out.

    In Configuration.h set

    #define X_HOME_DIR 1
    #define Y_HOME_DIR 1
    #define Z_HOME_DIR -1

    and in Configuration_adv.h

    Change #define X2_USE_ENDSTOP _XMAX_ to #define X2_USE_ENDSTOP _XMIN_

    and #define Y2_USE_ENDSTOP _YMAX_ to #define Y2_USE_ENDSTOP _YMIN_

     

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.