Assembly instructions

This topic contains 7 replies, has 3 voices, and was last updated by  Ryan 1 year ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #49767

    Dave
    Participant

    Hi all.

    Noob here. I was wondering if someone can point me to some assembly instructions for the MP3DP. Including flashing the firmware needed on the Ramps 1.4. I would appreciate it very much.

    Thanks in advance

    Dave C

    #49768

    Ryan
    Keymaster

    There really aren’t any other than the pics on the project page. The flashing instructions are on the firmware page, just use the correct file.

    If you get stuck just post a question, most of it is pretty straight forward, anything that isn’t one of us will load some pictures up for you.

    #49777

    Dave
    Participant

    Thanks Ryan, I will check it out. I appreciate your help.

    Dave

    #63064

    Robert
    Participant

    Very happy with the new Low rider performance, except the Z assembly or the (gantry) drops every time I reset the controller in order to zero x-y-z before start the program. could it be cause the steppers are not strong enough. Alternatively. How can I zero all without reset on the controller. Or, power off and on. any help will be appreciated.

     

    #63069

    Ryan
    Keymaster

    When resetting the board your steppers will not be powered up and the gantry will drop. In the instructions it shows how to add gcode to your program that will reset it without a power down.

     

     

     

    1 user thanked author for this post.
    #63070

    Ryan
    Keymaster

    Step 4

    #63092

    Robert
    Participant

    Hi Ryan: is that ( G 92 x0 y0 z0 ) ?

    #63102

    Ryan
    Keymaster

    Yeah G92 X0 Y0 Z0, sorry I was not at a computer yesterday.

    1 user thanked author for this post.
Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.