Artistic Designs with Inkscape, Eggbot Tools, and ESTLCAM

New Home Forum ZenXY Software – ZenXY Artistic Designs with Inkscape, Eggbot Tools, and ESTLCAM

This topic contains 32 replies, has 10 voices, and was last updated by  Tim W 4 months, 1 week ago.

Viewing 3 posts - 31 through 33 (of 33 total)
  • Author
    Posts
  • #100834

    Mark Harris
    Participant

    I am having trouble around these steps;

    • 12. Open DXF in ESTLCAM.
    • 13. Select the hatching lines and the square outline.
    • 14. Place the Zero point where you want it (I use 0,0)
    • 15. Save the CNC program. The simulator will pop up.

    I don’t seem to get the hatching lines selected properly because when I save the “CNC Program” I get an error message “There are no objects yet…”

    error
    I’m sure I’m just missing something. Any help would be appreciated.

    Mark

    Attachments:
    #100838

    Aaron
    Participant

    You need to tell it what to do. On the line? Inside or outside the square? How deep?

    #100847

    Tim W
    Participant

    Select Part, Hole, Engrave, and the tool then program

Viewing 3 posts - 31 through 33 (of 33 total)

You must be logged in to reply to this topic.