Archim + Laser

Tagged: ,

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #110491

    Paul
    Participant

    G’day,

    Please help, I would like to know how to set a Archim 1.0 board for a TTL laser control. I have spent some time on Google no luck. On the V1 laser page suggest pin 53? lots of help would be appreciated please keep in mind I’m new to this.

    #110559

    Ryan
    Keymaster

    There are a few videos on editing Marlin for this. It is kinda complicated depending on how much you understand of the programming stuff. You will need to switch the pins file and config adv. I am sure there are a ton of videos on it. I am pretty sure Teaching tech just did a laser video, different board but he showed the editing part.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.