- February 19, 2017 at 6:20 pm #27954
X and y travel only about 40% of request, ie 100 mm manual request from Repetier gets 40 mm.
z travel is good.February 19, 2017 at 6:28 pm #27955
1) Did you buy everything from here? Yes
2) Are you using end stops? Nope
3) PCFebruary 19, 2017 at 6:32 pm #27956
Check your pulleys. Are they tightened?February 19, 2017 at 8:15 pm #27963
How are you coming up short? Gcode, manual, what software. Zip up the gcode lets have a look.February 20, 2017 at 8:01 am #28009
all set screws are tight on stepper drive wheels
feels like teeth per mm is off somewhere? but i am a noob?
also resists going past 200 mm in either x or y direction (80mm) see test file drawing
manual moves above test drawing
I reflashed with the marlin.ino file the other day
Attachments:February 20, 2017 at 8:22 am #28014
Are you using my firmware? 200mm is a 3d printer thing, I have that turned off in mine.February 20, 2017 at 3:23 pm #28058
So I am looking at this page https://www.v1engineering.com/marlin-firmware/
Felt a bit confused before, and I am still confused by which “firmware I need from above”?
I do have an LCD screen from you also.
I may have gotten the correct file from http://code.google.com/p/u8glib/wiki/u8glib added to my Arduino library, but I am not sure if I did or how I would know.February 20, 2017 at 5:09 pm #28063
I flashed with RC7_MPCNC_LCD_9916.ino, works much better now.
You must be logged in to reply to this topic.