Angled Pocket?

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 6 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #39780

    Peter A Mills

    Is there any way to setup an angled pocket in ESTLcam so it gets deeper from one side to the other using a V-bit?

    I’m starting on the Open Source Beehive:

    It calls for an angled pocket for the entrance for the bees and another in the roof. I don’t know how to program that.

    Anyone done this project? I’m going to have some other questions because the colors in the instructions aren’t clear and I don’t have enough experience to know how to open any of the models and take them apart to inspect the parts.

    I don’t have a Low rider (yet) so I’m also going to have to break it up into 24×24″ pieces. More waste, but it should be able to be done.

    Many thanks.



    Yup, it is best to have a bit at the same angle as the cut needs to be, the just follow the cut path and it leaves you an angle.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.