An Enclosure Box

This topic contains 0 replies, has 1 voice, and was last updated by  Dan 11 months, 3 weeks ago.

Viewing 1 post (of 1 total)
  • Author
  • #30687


    Over the last week or so I put together an enclosure box around my MPCNC to cut down on the dust. It was built with a lot of scrap I had around; nothing fancy. The last thing to do is to connect a shop vac to the rear of the enclosure. Even though the center assembly is really beefy, I didn’t want to attach anything to it and create extra torque on the thing.

    Here’s the vid:


Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Pin It on Pinterest