May 11, 2019 at 10:35 pm #100166
Hi all. I’m nearly up to wiring my MPCNC, and I’ve got some braid sleeve (might need to by some larger stuff for the tape measure) but I can’t find a very detailed guide to the tape measure trick.
I’ve gone over the “Red/Black Milwakee” build with a fine tooth comb, but some detail photos of the joins, connections, lengths to run etc would be good.May 12, 2019 at 1:44 pm #100221
This is about all there is on that subject as far a I can find.May 13, 2019 at 3:16 pm #100366
This is how I used it for the lowrider. Maybe the pictures can help you visualize it for your application.May 14, 2019 at 6:55 pm #100513
Here is mine, if it helps…
in my post is a Thingiverse link to the Z axis bracket I made.May 14, 2019 at 9:47 pm #100528May 15, 2019 at 11:16 pm #100655
Thanks for replies.will go over those carefully.
Ryan, I mean where to ziptie, which direction, how long etc.May 16, 2019 at 6:33 am #100677
I think you are overthinking it. Just zip them into a convenient place.
You must be logged in to reply to this topic.