Tagged: Offset Firmware X Y axis error
- July 10, 2017 at 3:30 pm #37941
Here’s whats happening physically, I purchased everything from here last year around May.
In Repetier it’s showing this.
Also Hello World!
Thank you so much for all the work!July 10, 2017 at 3:38 pm #37942
TRouble shooting 3D printing is a bummer, a million things can be wrong. Can we try it another way.
If you follow this page, https://www.v1engineering.com/assembly/software/ does everything work including drawing the picture? If it doesn’t draw the picture well do not go any further until it does.July 10, 2017 at 3:53 pm #37943
Thank you! I’ll run these steps ttys!July 21, 2017 at 10:33 am #39047
I’m back finally!
Had to find these hooks for the potentiometers I’ve got the axis’s set but I was wondering about the Stepper voltage on the Extruder driver?July 21, 2017 at 10:43 am #39049
All depends on your extruder stepper. Each batch I get seems to be a little different. I would start at 0.65V. If after 20 minutes of use the stepper is hot turn it down, warm is good, cold means more power.July 21, 2017 at 11:33 am #39051
That’s such an excellent rule, Wouldn’t hurt to cool them right? I gotta make a freecycling trip and pull some fans.
So adjusting the voltage of the axis’s could they be “overclocked” or I guess tuned to run faster prints or we bound to some laws here?July 21, 2017 at 3:04 pm #39060
Anything you gain by adding power you will lose by moving around a fan. Proper tune is best as we always have them engaged.July 21, 2017 at 4:06 pm #39064
THANK YOU! I finally got it to run I’ll post up Pictures soon! (Maybe even a 4K Video!)July 21, 2017 at 5:54 pm #39068
Okay so I ran into MINTEMP Error then realized the thermistor has a short…
Honeywell 100K Thermistor 135-104LAG-J01
Should work as a replacement?July 22, 2017 at 6:11 am #39082July 22, 2017 at 8:25 am #39092
Awesome! I ordered those last night actually after more searching got them in time for two day shipping so we’ll see how it goes tomorrow! Thank you again, I hope you have a great weekend ttys!
You must be logged in to reply to this topic.