- June 28, 2017 at 4:26 am #36961
Im in the process of building the new version of middle assembly andI am having a little doubt.
I’ve printed the F_XYZ_T8 part (I couldn’t find the normal one to download)
and in the photo sequence showing how to assemble the parts, it says to insert a bearing between the spacer and the F_XYZ_T8 parts. I dont understand how should I insert the bearing in place of the T8 withot flipping the F_XYZ_T8 part but doing so it dosnt seem correct…
So should I print F_XYZ with bearing housing? I cannot find it on the thingiverse site.
Pinko97June 28, 2017 at 5:58 am #36964
Ok, I think I’ve understood… The bearings that instructions talks about should be inserted in the black F_XY part… 🙂
Sorry!June 28, 2017 at 7:28 am #36967
Don’t apologize. Someone is going to have that same problem in a bit, and they will find this post, and say nothing, but move onto happy cutting. I’ve done it 10k times. Public troubleshooting is the best.June 28, 2017 at 7:40 am #36969
Oye…my instructions are starting to fall behind again. I have had a a lot of emails about people missing the coupling nut in there kit and how pissed they are when they absolutely can’t finish assembling it. Then I tell them they have an “upgraded kit” then they are happy.
I have put this on the list of things to do….reluctantly…and I will look into this section as well pinko, sorry for the shite instructions. As you can imagine I like to make things more than make instructions.
You must be logged in to reply to this topic.