A question regarding the "Gantry_Spacer_C"

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC A question regarding the "Gantry_Spacer_C"

This topic contains 2 replies, has 2 voices, and was last updated by  c_rt_prf 1 month, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #111636

    c_rt_prf
    Participant

    I just finished printing both Gantry Spacer parts with the recommended infill settings of 55%.
    Is it OK that the “winged” parts on the side are hollow like this? They flex quite a bit (one more than the other), but don’t crack off easily.

     

    Attachments:
    #111638

    Deek
    Participant

    My opinion, should be ok. They are there just to hold the other side snug against the inside of the pipe until the bolt/nut is snug. Once it’s tightened up they serve no purpose.

    2 users thanked author for this post.
    #111640

    c_rt_prf
    Participant

    My opinion, should be ok. They are there just to hold the other side snug against the inside of the pipe until the bolt/nut is snug. Once it’s tightened up they serve no purpose.

    Thanks so much! That’s what I kind of assumed but I wanted to make sure.

    About 50% done with all of my prints now 🙂

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.