3D Printed Parts

New Home Forum LowRider Advice – LowRider 3D Printed Parts

Tagged: 

This topic contains 2 replies, has 2 voices, and was last updated by  Ryan 9 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #54184

    Brent
    Participant

    Not sure if this has been asked in the past.  But for all the LowRider printed parts.  About on average how much filament is needed?

    #54185

    Brent
    Participant

    Oh I did forget to mention, yes I do know it depends on the fill, and other factors, just wondering how much I would typically go through.

    #54192

    Ryan
    Keymaster

    Using my recommendations, 82+ hours 1.35Kg

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.