3D machined Ring Holder

New Home Forum Things You Have Made 3D machined Ring Holder

This topic contains 2 replies, has 2 voices, and was last updated by  NVHEnginerd 4 weeks, 1 day ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #110601

    NVHEnginerd
    Participant

    Was playing with some organic modeling tools, ended up with this shape and went for it. The cheapie “ball” endmill I used was junk, not quite sure what I’m going to use the remaining 9 for.

    1 user thanked author for this post.
    #110658

    Ryan
    Keymaster

    I had a batch shipped to me and they were actually drill bits, AHAHAHAHAH, Well I guess that is sort of a ball end.

    That must have a been fun to watch getting carved, I haven’t done a 3D part in a while.

    #110693

    NVHEnginerd
    Participant

    It doesn’t measure out at 118* but it’s definitely a craptastic round over. I may try it again with some better tooling.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.