1/4" shank endmill, ball and V bit suppliers?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC 1/4" shank endmill, ball and V bit suppliers?

This topic contains 6 replies, has 3 voices, and was last updated by  Mike Atencio 1 week, 3 days ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #116662

    Mike Atencio
    Participant

    Anyone have a good contact for the 1/4″ x 1.25″ endmills, V bits, and ball end bits. Good and low cost. Single or double flute. Everything I find on Amazon seems cheesy and I don’t want poor quality – I just don’t know who to trust on there. $50 per bit is really pricey too so trying to find an affordable solution. Thanks

    #116663

    Deek
    Participant

    If you have a Rockler or Woodcraft store close by they have assorted Freud and Whiteside 1/4 bits. I’ve had good luck with them

    1 user thanked author for this post.
    #116672

    Barry
    Participant

    https://www.ebay.com/usr/drillman1?_trksid=p2047675.l2559

    Try here. This is where I get my stuff that’s not from Ryan’s store.

    1 user thanked author for this post.
    #116791

    Mike Atencio
    Participant

    We don’t have those stores here. Thanks

    #116792

    Mike Atencio
    Participant

    Just ordered a could of end mills. Thanks

    #117223

    Deek
    Participant

    https://www.ebay.com/usr/drillman1?_trksid=p2047675.l2559

    Try here. This is where I get my stuff that’s not from Ryan’s store.

    I also have bits from that store, all have been great!

    #117354

    Mike Atencio
    Participant

    I just got two from them. They look huge next to an 1/8″ endmill. I hope they fit lol.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.