Reply To: Mini Rambo Case?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Mini Rambo Case? Reply To: Mini Rambo Case?



At looking at the photos of the graphic controller on this site, I am wondering if the bottom edge of the controller will miss the dove joint used for the end cap shown in the attached photo. This joint is only about 2.5mm above the bracket and looks like it should be ok. If it is a problem, I could always add a little more height to where the controller mounts to the side bracket or I could shorten the dovetail joint so it does not extend the full width of the bracket.