Reply To: Mini Rambo Case?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Mini Rambo Case? Reply To: Mini Rambo Case?



I pull the full faceplate off the printer this morning. Everything seems to line up and fit fine. However, I think it will need a stand off for the screws that mount the LCD on the right side of the screen. Since this doesnt stretch to the other end like your longer LCD there is a gap between the faceplate and the board on the LCD that wont be filled by the brackets on the ends. Other than that with the little speaker pressed against the faceplate the fit of the LCD face looks good.