Reply To: Printed wheels?

New Home Forum LowRider Hardware Development – LowRider Printed wheels? Reply To: Printed wheels?


Very interesting. Thanks a lot for your post

Given how perfect the gap was between the center PLA part and the rubberish tire, I was assuming you were printing the two materials at once. Impressive.

I’m pretty sure rounding a bit the edge would not cause you any issue with warping or adhesion, but you know your printer more than I do 🙂

Anyway, good work.

I wonder how well those wheels could do on a skateboard/roller/scooter and how long they would resist to actual use abrasion. Would love to see, if you have any time or willingness to try it at some point!