Reply To: Estlcam under Linux?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Estlcam under Linux? Reply To: Estlcam under Linux?



I’ll have to give it another try. I had seen that post on cnczone and that was what I followed as best I could…but I’m not very familiar with playonlinux and some of the packages didn’t seem to match up. Could also just be the old notebook I was working on the issue since it was an older 32bit system.

I’ll have to boot up linux on my shop computer this weekend and see if it does any better (it’s only 4 or 5 years old but sadly my newest computer…well…other than the macbook air I get to use from work which I do most of my onshape work from.)