Reply To: Banggood laser – IT WORKS!

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Banggood laser – IT WORKS! Reply To: Banggood laser – IT WORKS!


GremlinRC, over on my FliteTest needle-cutter thread, shared his design for a shroud to enclose a similar 3.5 watt laser head from Banggood. I think it’s a little larger than the one you are looking at, and it’s not a shark, but it may give you ideas…!&p=320795&viewfull=1#post320795

We also played around quite a bit with air-assist… here’s my version installed on a 2′ x 2′ MPCNC

I kind-of glossed through a most of that thread, a lot of great information there, will go back and read the whole think when I have a chance, but I have a question. I think I saw you post that you felt the 3.5W banggood wasn’t any better than the Leo69 2.8W laser that you already had? Was I correct in that conclusion? Did you ever tweak on it to get a better output? Thanks!