Reply To: Inconsistent Cuts



Code is very similar. Depending on the cut/end mill I’m using F(xy)=15mm/sec and F(z)=5mm/sec, and Z+ (either .5mm or 1mm depending on endmill). On top of that I play with the feedrate multiplier in Repetier so those values are even less. (I usually have the federate between 65% – 80% for very fine 1/16″ bits)

G00 X0.0000 Y0.0000 Z0.0000 F2100
G00 Z5.0000 F480

;No. 1: Hole 2
G00 X6.9259 Y15.4885 F2100
G00 Z0.5000 F480
G01 Z-1.0000 F240 S24000
G01 X7.1721 F900
G01 X7.2085 Y15.7685 F900
G01 X6.5566 F900
G01 X6.4320 Y16.0485 F900
G01 X7.2161 F900
G01 X7.2167 Y16.3285 F900