New Home › Forum › Mostly Printed CNC – MPCNC › Troubleshooting – MPCNC › Home button in Repetier, moving x and y without power, lcd not doing much › Reply To: Home button in Repetier, moving x and y without power, lcd not doing much
1) Did you buy everything from here?
a)If you didn’t or changed some things please don’t leave out any details and include what firmware you flashed.
I didn’t change anything. I assumed it came pre-flashed with the correct firmware.
2) Are you using end stops?
a)If so please disconnect them.
3) Mac or PC?
PC Windows 10.
4) Include a picture so obvious errors might be spotted.
Attached. The cable on the right is my laptop power cable.
It says Vicious and has the logo when I power it on. My previous post has listed exactly what I purchased. The ip only shows up when the pc is hooked up.
I’ve attached two pictures. I tried to catch the Vicious logo, but missed it and ran out of time before work. I’ll take another picture this evening when I have more time. You’re seeing the screen right after the Vicious logo and the main screen. The x, y, and z alternate with ? indicating it’s not communicating I’m guessing.