Reply To: Mortice and Tennon Tolerances

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Mortice and Tennon Tolerances Reply To: Mortice and Tennon Tolerances



Ya, I’m using the dogbone script on all corners (set to 1/8″). I will measure the bit tonight and see if that’s it. Also measure the parts to see if they are too large or small. If not, then add a parameter. Have either of you done these and not had to add parameters for fit ?

Like I mentioned, I’m using the Kyocera. But in fusion I just grabbed an 1/8″ bit. However, 1/8″=3.175 mm in actual fact. So if it’s actually a 3mm bit, then my holes would be too small, and my tennon would be too big, correct ?