Reply To: bell bottom parts

New Home Forum Milled Printed 3D Printer -MP3DP Advice – MP3DP bell bottom parts Reply To: bell bottom parts



You should just sped the time to calibrate your first layer. You do not want to start, pause , and adjust every print. Spend the time to do it right once then you will almost never have to touch it again.

I think you will find the mechanical way is much easier than the “auto level” with sensors. The best prints are done with auto level off. Auto level drives your z axis continuously, with a non-autolevel printer it just moves up one time for each layer, The less axis moving at the same time the more precise your parts will be.

1 user thanked author for this post.