Reply To: My Adventures with the MPCNC

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC My Adventures with the MPCNC Reply To: My Adventures with the MPCNC


Dave B.

I rushed into trying my first cuts today and messed up the settings in Estlcam somehow…need to go through the basics again. Some cuts went well and deep enough but others were above the wood and some only scratched the surface. I also need to get some proper bits to do this for real so order has been made.

I built up a dual outlet power box with a remote dimmer switch for spindle control until the relay gets here as well, but of course I wired the dimmer backwards and it’s full power when I turn it on then fades to low as I increase the rotation. Derp!

No pics until I clean up these little things and try again. Maybe tomorrow with any luck.

Pin It on Pinterest