Reply To: Abs build



The ambient temp inside my enclosure is between 50 and 60 degrees Celsius.
Really need that when printing ABS to overcome any warping, also need to preheat the glass bed for at least 30 minutes before starting the print.
When done printing the part just pops loose when its slowly cooling down.

Regarding the printer temperature, here I am printing the Nutlock but no normal pic but FLIR (Cat s60 phone).

Printing the last roller now, about 3 hours left.
XYZ, XY, pineapple coupler and a couple other small bits and I should be ready to start building.